1/4 Scale Balsa USA Piper Cub - Big Electric Motor Install Draw Style Unit

Discuss & share your electric-powered airplane projects here!
User avatar
Neons
Site Admin
Posts: 499
Joined: Tue Nov 22, 2011 10:28 pm

Re: 1/4 Scale Balsa USA Piper Cub - Set Decals in Place

Post by Neons » Sat Dec 15, 2018 11:18 pm

Dec.10, 2018

Here it is almost ready to fly. All the decal registration numbers on top and bottom of the wing in place. The rudder has the Cub decal and reg. numbers in place also. Now it is starting to look like it should. World Models supplied the decal sheets. They are $10 per sheet.
Attachments
12-10-2018 Piper Cub - Finished (1).jpg
12-10-2018 Piper Cub - Finished (0).jpg
Bob Pacheco

User avatar
Neons
Site Admin
Posts: 499
Joined: Tue Nov 22, 2011 10:28 pm

Re: 1/4 Scale Balsa USA Piper Cub - Finished and Ready to Fly

Post by Neons » Sat Dec 15, 2018 11:24 pm

Dec.14,2018

Well this plane is almost ready. I just need a few bolts from Home Depot and tighten up the propeller nut. Now that you see the photos of it outdoors with me holding it up you see how large it is. About 108 inch wing and 70 inch fuselage. I still have to weigh the total weight and I want to do a video with the plane tied to a pole or tree and full throttle. I will post it here along with a YouTube video on maiden flight when it happens.
Attachments
12-14-2018 Piper Cub - Finished (14).jpg
12-14-2018 Piper Cub - Finished (13).jpg
12-14-2018 Piper Cub - Finished (12).jpg
12-14-2018 Piper Cub - Finished (4).jpg
12-14-2018 Piper Cub - Finished (10).jpg
12-14-2018 Piper Cub - Finished (8).jpg
12-14-2018 Piper Cub - Finished (5).jpg
Bob Pacheco

Post Reply