I got tired of cutting my fingers up when launching my flying wings so...

Post your Photos & Videos here!
Post Reply
jerryn
Site Admin
Posts: 52
Joined: Wed Jul 05, 2017 9:02 pm
Contact:

I got tired of cutting my fingers up when launching my flying wings so...

Post by jerryn »

I 3d printed landing gear mounts that glue on the Opterra 1.2 skid plate that's on the bottom of the fuselage.
I used the landing gear that was from the crashed HK Cessna.
Image
User avatar
Neons
Site Admin
Posts: 675
Joined: Tue Nov 22, 2011 10:28 pm
Location: youtube ne0ns1
Contact:

Re: I got tired of cutting my fingers up when launching my flying wings so...

Post by Neons »

Great looking wing. Happy flights, Those fly well.
Bob Pacheco
jerryn
Site Admin
Posts: 52
Joined: Wed Jul 05, 2017 9:02 pm
Contact:

Re: I got tired of cutting my fingers up when launching my flying wings so...

Post by jerryn »

It's the airplane that you and Gary recovered from the corn field for me. I went to the field last Friday to fly it. The landing gear worked but shortly after takeoff the motor burnt out, it started to smoke so I attempted to land it but the tail of the airplane got so hot that it melted and crashed.
I built another airplane today:
Image
Once a get some XT30 connectors I will be able to make a charger cable for it.
User avatar
Neons
Site Admin
Posts: 675
Joined: Tue Nov 22, 2011 10:28 pm
Location: youtube ne0ns1
Contact:

Re: I got tired of cutting my fingers up when launching my flying wings so...

Post by Neons »

If the motor burnt it may have used to many amps. You need to put a Whattmeter between the battery and the main ESC plug to see how many amps are being drawn at full rpm. If the prop is slightly oversize it can burn out the motor. Another way is to feel the motor after a few laps land it and feel the motor. You should not have a hot motor. Drop prop size slightly. Same with the ESC. Check with the Whattmeter and do not go over the listed amps.I have a spare for sale. $20. I do not care if i sell it or not.
Bob Pacheco
Post Reply

Who is online

Users browsing this forum: No registered users and 9 guests